Quantum Scalar i6000 - Configure AMP Import Policies; Configure AMP Auto Export Policies

Chapter 6: Automated Media Pool
Configure Automated Media Pool
Quantum Scalar i6000 User’s Guide 277
Configure AMP Import
Policies
You can only configure import AMP policies on standard partitions (not
library managed partitions).
1 Click Setup > Partitions > Policies > Auto Import Configuration.
The Auto Import Configuration dialog appears.
2 For a specific partition, enter a range of barcode numbers in the
Enter Import Filter field. Multiple filters can be listed but must be
separated by a semi-colon.
3 Click OK.
Note: Import filters will be applied to the barcode label only. The
filters will not consider any media ID (e.g. L4, L5, etc) on the
barcode.
Configure AMP Auto
Export Policies
You can only configure export AMP policies on standard partitions (not
library managed partitions). However, this export function cannot be
performed from the user interface. Instead, any SCSI MOVE commands
performed on the standard partition to an assigned I/E elements will