Chapter 15: Maintaining Your Library
Maintenance Actions
Quantum Scalar i6000 User’s Guide 601
calibration targets, even slightly, you should initiate the calibration
teach process.
1 Log on as an administrator.
2 Make sure that you are viewing the physical library. From the View
menu, click the name of the physical library.
3 Click Too l s > Te a c h . The Te a c h dialog box appears with Configure
selected by default.
Note: If the physical library is not offline, you receive a message
that asks you whether you want to take it offline. Click Yes.
4 Select Calibrate.
5 Click Start.
During the calibration teach process, the picker moves to the home
position, which is X-Y coordinate position 0,0. Then, for each rack of
each module, the picker moves to a magazine at the top and one at
the bottom and stores those positions in coordinates relative to the
0,0 position. Teach results appear in the Results area when the
process completes.
Note: Use the Physical Library command on the Setup menu to
disable or enable automatic inventory after a calibration
teach. For more information about this command, see
Setting Up Policies for the Physical Library on page 180.
Saving and Restoring
Library Configuration
The library’s save and restore capabilities enable you to save a remote or
local copy of configuration settings for the library’s drives, I/O blades,
and partitions, including the allocation of drives, storage magazines,
To Next Page
Loading...
Need help?
General