Quantum Scalar i6000 User’s Guide 1
Chapter 1
Description
The Scalar i6000 library automates the retrieval, storage, and control of
tape cartridges. Application software on the host can use the library’s
robotics to mount cartridges into tape drives and retrieve them without
operator intervention.
The library can be installed on a solid or raised floor. It has a standard
19-inch rack footprint and can be placed in a standard server rack space.
Because the library provides access by way of the access and service
doors, the library can be placed with either side against a wall or
between racks.
In December, 2011, the library robotics were redesigned. The redesign
accommodates either a single robot or dual robotics. The original robot
hardware is referred to as Gen 1; the new robot hardware is referred to
as Gen 2.
With firmware version i11, robots in a dual-robot system work in an
active/active manner, where both robots perform move commands and
other library operations.
In March 2013, the library electronics were redesigned, including a new
second generation Management Control Blade (MCB 2). The electronics
redesign is referred to as Gen2 Electronics and is required for to support
new features, such as Active/Active operation for Dual Robots and the
High-Density Expansion Module (HDEM).
In June 2015 new Series 3 modules were released for the Control
Module (CM3), Drive Ready Expansion Module (DREM3) and Storage
To Next Page
Loading...
Need help?
General