Quantum Scalar i6000 User’s Guide 497
Chapter 14
Using the Command Line
Interface
Customers as well as Technical Support personnel can access the library
using a command line interface (CLI). The CLI is fairly rudimentary and
only covers a small portion of the commands available on the library
user interface. The CLI is not intended to replace the GUI, but, rather, to
be an additional tool that can be used if desired.
This chapter covers:
• Logging on to the CLI on page 498
• Command Line Interface (CLI) Commands on page 499
• Initial Path on page 499
• Navigating Paths on page 499
• Global Commands on page 500
• Path-specific Commands on page 502
• Issuing a Command from the Initial Prompt on page 503
• CLI Command List on page 503
Note: The CLI uses the term “mail slot” to mean I/E station slot.
To Next Page
Loading...
