Quantum Scalar i6000 - Command Line Interface (CLI) Commands; Initial Path; Navigating Paths

Chapter 14: Using the Command Line Interface
Command Line Interface (CLI) Commands
Quantum Scalar i6000 User’s Guide 499
Command Line Interface (CLI) Commands
Navigate through the CLI by typing names of paths or commands. Once
you reach an intended path, you can execute a command from that
path.The paths can be thought of as a tree with the Initial path as the
root.
Initial Path The initial path is empty, and is displayed as in the following figure.
The initial path is displayed as a '/' character. The path is always followed
by a '>' character.
Navigating Paths The user types in paths, and then presses enter on the keyboard to
navigate up and down paths. In the following example, the user typed
set. This action changed the prompt, allowing a different set of
commands and paths to become available. The user then typed
drive.
The new path is now
/set/drive.
Welcome to the XXX Library Command Line Interface.
Type 'help' at the prompt for context-sensitive help.
/>
Welcome to the XXX Library Command Line Interface.
Type 'help' at the prompt for context-sensitive help.
/> set
/set> drive
/set/drive>