Chapter 3: Configuring Your Library
Specifying the Date and Time
186 Quantum Scalar i6000 User’s Guide
4 In the NTP section
• If you choose to enable NTP, click Enable.
The Date and Time sections of the dialog box are grayed out.
• Type valid IP addresses for the Primary Server and optionally
the Secondary Server and Tertiary Server.
• If the DNS Server has not been configured in the LMC, type
valid numeric IP addresses that are accessible from the
library (example 111.11.11.111). Go to step 7.
• If the DNS Server has been configured through the LMC
(Setup > Network Configuration > DNS Configuration),
type the valid alpha/numeric IP Addresses that are accessible
from the library. Go to step 7.
• If NTP is enabled and you no longer want to use this setting,
click Disable.
To Next Page
Loading...
