Radioddity DB25-D - Page 113

Radioddity Extended manual for Radioddity DB25-D, DB40-D & GD-88 v3.0
© Radioddity 2023 page 113 of 252
3. Press the [Select]-key to light up the cursor and enter the editing mode.
4. Rotate the [ENC] knob or use the [▲/▼]-keys to choose the desired value and
press the [Select]-key to confirm and save.
5. Press the [Back]-key to return to the previous level.
Notes: Press the [Back]-key to return to the previous level.
Parameter
Possible Values
Channel Attribute
Digital/Analog/RX:D/A-TX:A/TX:D/A-RX:D
FreqStep
5kHz/6.25kHz/10kHz/12.50kHz/25kHz/50kHz/100kHz
RX Frequency
In the available range of the radio
TX Frequency
In the available range of the radio
Power
High/Low
RxTS
Time Slot 1 / Time Slot 2
TxTS
Time Slot 1 / Time Slot 2
RxCCe
Color Code 0 …15
TxCC
Color Code 0 …15
Alarm*
Alarm: ON/Alarm: OFF
CallAlert*
ON/OFF
PCallType*
PATCS/OACSU
MsgType
PATCS/OACSU
Permission
Impolite/Polite to CC/Polite To all
Rx Group
OFF/<self-defined RX-Groups>
Encpty
Enc: OFF/<self-defined Encryption alias >
Contact
Contact: OFF/<self-defined Contacts >
Emergency*
Emergency: OFF//<self-defined Digital Alarm lists>
DMR APRS
APRS reporting slot (1…8/OFF)
Bandwidth
Wide/Narrow
TxSubType
Signaling Off/CTCSS/DCS/DCS Reverse
TxSubItem
The signal codes of CTCSS, DCS and DCS Reverse
RxSubType
Signaling Off/CTCSS/DCS/DCS Reverse
RxSubItem
The signal codes of CTCSS, DCS and DCS Reverse
ScanList
OFF/<self-defined scan lists>
Rx Only
Limit the channel to only receive (ON/OFF)
SaveVFO**
Save setting to currently selected VFO
Save2CurChn*
Save setting to currently selected channel
Save2SelChn
Save settings after selecting target channel from list
*) Not available for digital VFO mode
**) Only available in VFO mode
Notes: FreqStep is only available for digital VFO mode