Radioddity Extended manual for Radioddity DB25-D, DB40-D & GD-88 v3.0
© Radioddity 2023 page 248 of 252
When editing the
parameters of the VFO
marked with PTT the
parameters of the other
VFO get changed
When editing parameters using the radio
menus, the changes do apply to those VFO
that´s marked with ‘CTRL’. Make sure to select
the proper VFO for ‘CTRL’ using the ‘A/B’ key.
I am not able to TX to my
Hotspot using DMR-mode
Make sure the setting for ‘TimeSlot’ of the
corresponding channel is set either to the
required TimeSlot (for duplex hotspots) or to
‘ON’ for simplex hotspots.
The Radioddity DB25-D,
DB40-D is OFF
whenever I power
on my car
The Radioddity DB25-D, DB40-D does keep its
last power state upon loss of power. If the
radio had been turned on before power loss, it
will automatically turn on again as soon as the
power is back. If it had been turned off before
power loss, it will stay off, even if power is back.
Every time I need to set the
audio volume of my
Radioddity DB25-D,
DB40-D
The actual audio volume highly depends on the
audio volume of the transmitting station.
However, if you do change the volume settings
on your Radioddity DB25-D, DB40-D by hitting
the [VOL]-key, turning the [ENC]-knob, then do
not forget to press the [ENC]-knob to
permanently store the setting into the radio.
The [ENC]-knob for channel
selection does not work
Channel selection has been disabled by the
user. To reenable the channel selection do the
following: MENU → Local Set → Channel Sw →
Select (the switch-icon should turn GREEN to
allow using the ENC-knob for selecting a
channel)
Function assigned to a
programmable [P]-key does
not work
Functions only available when an analog
channel is selected do not work on digital
channels. Functions only available for digital
channels do not work on analog channels. If a
pilot tone / burst tone has been assigned to
short press of a programmable [P]-key, the
long press function for that very same [P]-key is
no longer available.
My radio came with a
codeplug already installed,
is it a used radio?
No, you did not at all get a used radio. We do
ship the DB25-D, DB40-D and GD-88 with a
preconfigured sample codeplug that has, for
your convenience, also been written to the
radio as 'factory reset' codeplug. This sample
codeplug contains various sample settings that
should give you an idea on the various
operating modes.
To Next Page
Loading...
