R&S FSPN - Page 384

Remote Control
R&S
®
FSPN
384User Manual 1179.4363.02 ─ 01
CONFigure:SNTune:SWEep:STARt <Value>
This command defines the start value of the tuning range.
Parameters:
<Value> <numeric value>
The unit depends on whether you tune the VCO with a voltage
or current (see CONFigure:SNTune:SWEep:SOURce).
*RST: 0
Default unit: V or A
Example: See CONFigure:SNTune:SWEep:SOURce.
Manual operation: See "Defining the sweep range" on page 128
CONFigure:SNTune:SWEep:STOP <Value>
This command defines the stop value of the tuning range.
Parameters:
<Value> <numeric value>
The unit depends on whether you tune the VCO with a voltage
or current (see CONFigure:SNTune:SWEep:SOURce).
*RST: 0
Default unit: V or A
Example: See CONFigure:SNTune:SWEep:SOURce.
Manual operation: See "Defining the sweep range" on page 128
11.6.8.2 Trace Configuration
Commands to configure traces described elsewhere:
●
CALCulate<n>:SNOise<s>:AOFF on page 372
●
CALCulate<n>:SNOise<s>:STATe on page 372
●
CALCulate<n>:SNOise<s>:X on page 372
●
DISPlay[:WINDow<n>]:TRACe<t>:MODE on page 413
●
DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<t>[:STATe] on page 416
[SENSe:]SMOothing:APERture....................................................................................... 384
[SENSe:]SMOothing[:STATe]...........................................................................................385
[SENSe:]SPURs:SUPPress............................................................................................ 385
[SENSe:]SPURs:THReshold........................................................................................... 386
[SENSe:]SMOothing:APERture <Value>
This command defines the magnitude (aperture) of trace smoothing.
Common Measurement Settings