Getting started
R&S
®
TSMA6
33User Manual 4900.8057.02 ─ 11
●
Input/output: Synchronization with up to 4 connected R&S TSME6 resp. R&S
TSMExxDC (requires sync cable R&S TSME6-ZC2, R&S no. 4900.1800.02 or R&S
TSME6-ZC4, R&S no. 4900.1817.02)
●
Input: Synchronization of R&S TSMA6 with an external 10 MHz reference (requires
dedicated sync cable)
SCAN port - GBit LAN interface - external R&S TSME4/6 (RJ45 connector)
See (9) in Figure 3-7.
The SCAN port provides a high-speed 1 Gbit Ethernet interface with an RJ 45 connec-
tor. It is used to connect the R&S TSMA6 to a separate R&S TSME6 as a second
scanner. It can be used for MIMO scenarios and for increasing bandwidth and mea-
surement rate.
WLAN/Bluetooth on/off
See (10) in Figure 3-7.
Switches WLAN and Bluetooth on and off.
RF IN connector (SMA)
See (11) in Figure 3-7.
RF input of the device.
The maximum input power is +20 dBm/10 V DC.
Do not overload the maximum allowed input of +20 dBm.
Non-compliance destroys the input mixer.
GPS Ant. connector (SMA) - GPS antenna input
See (12) in Figure 3-7.
Active GPS antenna port (output voltage 3V, max 25 mA).
USB-C (multiport for Thunderbolt, display and standard USB-C 3.1)
See (14) in Figure 3-7.
Connecting external storage devices, tablets and test mobile phones.
Total power (USB-C): max. 3 A
Overall USB current (USB-C, USB 3.0 and USB 2.0): max. 3 A
LAN Port - remote control (RJ45 connector)
See (15) in Figure 3-7.
The LAN port provides a high-speed 1 Gbit Ethernet interface with an RJ 45 connector.
It is used to connect the R&S TSMA6 to a LAN/WAN.
The LAN interface can be used for the following scenarios.
●
Remote Control via web-GUI
Instrument tour
To Next Page
Loading...
