PRINTER AND P/S OPTIONS
SM 11 D315
Printer/
Scanner Unit
D315
1.2.4 PRINTER ENHANCE, SCANNER ENHANCE OPTIONS
Accessory Check
Refer to the "Common Accessory Table" on page 6.
Installation (Application Merge)
The installation of the printer enhance option and scanner enhance option is done
with SP5873 001 (Application Merge).
NOTE:
• If you are going to update the RPCS unit with both the printer and scanner
enhance options, the order of execution is not important.
• For more details about merging more than one application with SD card in slot
C1, refer to the merge maps ( pg.13).
1. Turn off the copier.
2. Remove the SD card slot cover ( x1).
3. Confirm that the RPCS Printer Unit SD card is in SD card Slot C1.
4. Put the option SD Card (Printer Enhance Option or Scanner Enhance Option)
in SD card slot C3.
5. Open the front door.
6. Turn the copier on.
7. Go into the SP mode and select SP5873 001.
8. Touch "Execute".
9. Read the instructions on the display and touch "Execute" to start.
10. When the display tells you copying is completed, touch "Exit", then turn the
copier off.
11. Remove the option SD card from C3.
12. Close the front cover and turn the copier on.
13. Go into the User Tools mode and confirm that update was successful.
User Tools> System Settings> Administrator Tools> Firmware Version> Next
14. Turn the copier off again, and then reattach the SD card slot cover.
15. Return the copied SD card to the customer for safekeeping, or tape it to the
faceplate of the controller.
To Next Page