PRINTER AND P/S OPTIONS
D315 12 SM
To undo an option update
1. Turn the main switch off.
2. Confirm that the RPCS Printer Unit SD card is in SD card Slot C1.
3. Put the original option SD card (Printer Enhance Option or Scanner Enhance
Option) in SD card slot C3.
4. Turn the main switch on.
5. Go into the SP mode and do SP5873-002 (Undo Exec).
6. Follow the messages on the operation panel to complete the procedure.
7. Turn the main switch off.
8. Remove the option SD card from Slot C3..
9. Turn the main switch on.
10. Go into the User Tools mode and confirm that undo was successful.
User Tools> System Settings> Administrator Tools> Firmware Version> Next
11. Turn the copier off again, then reattach the SD card slot cover.
Important Notes About SD Cards
Here are some basic rules about merging applications on SD cards.
• The data necessary for authentication is transferred with the application program
to the target SD card.
• The SD card is the only evidence that the customer is licensed to use the
application program. The service technician may occasionally need to check the
SD card and its data to solve problems. SD cards must be stored in a safe
location at the work site.
• Once the merge is completed, the SD card from which the application was
copied cannot be used again, but the customer must keep the card to serve as
proof of purchase.
• An SD card from which an application has been moved to another SD card can
be restored to full operation with SP5873 002 (Undo).
• Before storing the card from which an application has been copied, label it
carefully so that you can identify it easily if you need to do the undo procedure
later.
To Next Page
Loading...
