What to do if diagnostics test failed on Rockwell Automation Relays?
If the diagnostics test fails during power-up or reset indicating an internal fault, first cycle the power to the unit. If the fault persists after power cycling, replace the unit.
What to do if I have duplicate EtherNet/IP module address on my Rockwell Automation Relays?
If you encounter a duplicate EtherNet/IP module address error, it means two modules are configured with the same address. To resolve this, change the IP address to a valid, unique setting and then reset the device.
What to do if E300 EtherNet/IP Communication Module is not properly connected to an Ethernet network for Rockwell Automation Allen-Bradley E300?
If the E300 EtherNet/IP Communication Module isn't properly connected to the Ethernet network, check the Ethernet cabling to ensure it is correctly installed.
Why is my Rockwell Automation Allen-Bradley E300 E300 EtherNet/IP Communication Module not receiving power?
If the E300 EtherNet/IP Communication Module is not receiving power, verify that the correct control voltage exists between terminals A1 and A2 on the E300 Control Module.
What to do if E300 Overload Relay is in a fault state for Rockwell Automation Allen-Bradley E300 Relays?
If the E300 Overload Relay is in a fault state, reset the E300 EtherNet/IP Communication Module or verify the validity of the data in the configuration assembly.
What to do if E300 EtherNet/IP Communication Module is online, but with no connections established for Rockwell Automation Relays?
If the E300 EtherNet/IP Communication Module is online but no connections are established, check the EtherNet/IP master and its scan list for the correct scanner configuration.
What to do if E300 EtherNet/IP Communication Module is not being scanned by the EtherNet/IP master for Rockwell Automation Allen-Bradley E300?
If the E300 EtherNet/IP Communication Module is not being scanned by the EtherNet/IP master, check the Ethernet scan list for the correct scanner configuration.
What to do if EtherNet/IP connections timed out on Rockwell Automation Relays?
If one or more EtherNet/IP connections have timed out, reset the EtherNet/IP master device.
General| Category | Electronic Overload Relay |
|---|---|
| Control Voltage | 24V AC/DC |
| Ambient Temperature | -20 to 60°C |
| Voltage | 690 V AC max |
| Communication Protocol | EtherNet/IP, DeviceNet, Modbus RTU |
| Protection Type | Overload, Phase Loss, Ground Fault, Jam, Undercurrent |
| Mounting Type | DIN Rail |
| Trip Class | 10, 20, 30 |
| Display | LCD |
| Standards Compliance | UL, CE |
To Next Page