Rohde & Schwarz R&S SGS100A - Page 278

Remote control commands
R&S
®
SGS100A
278User Manual 1173.9105.02 ─ 13
// Select the external modulation source
SOURce:PULM:SOURce EXT
// Set the polarity of the externally applied modulation signal.
SOURce:PULM:POLarity NORMal
// Select the impedance for the external pulse modulation trigger input
SOURce:PULM:TRIGger:EXTernal:IMPedance G10K
// ******************************************************************
// Configure the pulse generator settings
// ******************************************************************
// Set pulse period
SOURce:PULM:PERiod 10 us
// Set pulse width
SOURce:PULM:WIDth 8 us
// Set double pulse width
SOURce:PULM:DOUBle:WIDTh 0.0000012
// Set double pulse delay
SOURce:PULM:DOUBle:DELay 0.0000045
// ******************************************************************
// Activate the signal output
// ******************************************************************
SOURce:PGENerator:OUTPut:STATe 1
SOURce:PULM:STATe 1
OUTPut1:STATe 1
[:SOURce<hw>]:PULM:DELay........................................................................................ 278
[:SOURce<hw>]:PULM:DOUBle:DELay............................................................................279
[:SOURce<hw>]:PULM:DOUBle:WIDTh........................................................................... 279
[:SOURce<hw>]:PULM:MODE........................................................................................ 279
[:SOURce<hw>]:PULM:PERiod....................................................................................... 279
[:SOURce<hw>]:PULM:POLarity..................................................................................... 280
[:SOURce<hw>]:PULM:SOURce..................................................................................... 280
[:SOURce<hw>]:PULM:STATe.........................................................................................280
[:SOURce<hw>]:PULM:TRIGger:EXTernal:GATE:POLarity.................................................281
[:SOURce<hw>]:PULM:TRIGger:EXTernal:IMPedance...................................................... 281
[:SOURce<hw>]:PULM:TRIGger:EXTernal:SLOPe............................................................ 281
[:SOURce<hw>]:PULM:TRIGger:MODE...........................................................................281
[:SOURce<hw>]:PULM:WIDTh........................................................................................282
[:SOURce<hw>]:PULM:DELay <Delay>
Sets the pulse delay.
Parameters:
<Delay> float
Range: 0 to 100 s
Increment: 10 ns
*RST: 10 ns
SOURce:PULM Subsystem