Startup Guide Flow
120
10. Tap the media sensor type from the list.
[None]
Disable the media sensor.
[Gap]
Select this option when using gap type media. Use the transmissive type sensor.
[I-Mark]
Select this option when using I-mark type media. Use the reflective type sensor.
• The available options will vary depending on the [Print Mode] set on the printer. The
initial value of [Print Mode] differs depending on the options installed on the printer and
the way media is loaded.
◦ If [Print Mode] is set to [Dispenser], only [Gap] and [I-Mark] will be available.
◦ If [Print Mode] is set to [Linerless tearoff] or [Linerless cutter], only [None] and [I-
Mark] will be available.
If you have selected something other than [I-Mark], proceed to step 12.
To Next Page
Loading...
