SATO FX3-LX - Page 285

285
The setting items are as follows:
[Change Printhead]
Enable or disable the notification function about when the print head needs to be replaced.
[Printhead Interval]
Set the notification interval about when the print head needs to be replaced.
You can change the setting only if you enabled the [Change Printhead] menu.
The printer shows the print distance as a setting value. The setting range is from 10 to 100 km.
[Printhead Count]
Shows the current print distance.
[Change Cutter]
Notify when the cutter unit needs to be replaced.
The setting items are as follows:
[Change Cutter]
Enable or disable the notification function about when the cutter unit needs to be replaced.
[Cutter Life]
Set the notification interval about when the cutter unit needs to be replaced.
You can change the setting only if you enabled the [Change Cutter] menu.
The printer shows the cutter count as the setting value. The setting range is from 10,000 to 1,000,000
cuts.
[Cutter Count]
Shows the current number of cuts by the cutter.
[Change Platen]
Notify when the platen roller needs to be replaced.
The setting items are as follows:
[Change Platen]
Enable or disable the notification function about when the platen roller needs to be replaced.
[Platen Interval]
Set the notification interval about when the platen roller needs to be replaced.
You can change the setting only if you enabled the [Change Platen] menu.
The printer shows the fed distance as the setting value. The setting range is from 10 to 100 km.
[Platen Count]
Shows the current distance the platen roller has fed.