[Wi-Fi Setting]
326
Mode Data format
Legacy
status
([Legacy
Status for
Port 9100]
is enabled)
[BCC]
Enable or disable the BCC check function.
Appears only if you have selected [STATUS5] in the [Flow Control] menu.
[Delay Reply ENQ]
Set the period to delay status reply to status request ENQ.
Available only if you have selected [STATUS3], [STATUS4 ENQ], [STATUS5], or [NONE] in the [Flow
Control] menu.
The setting range is from 0 to 9999 ms.
• Normally, keep this setting at the initial value.
[Status4 Cyclic Response]
Set the interval for the cyclic status response.
Available only if you have selected [STATUS4] in the [Flow Control] menu.
The setting range is from 100 to 999 ms.
[Wi-Fi Protected Setup(WPS)]
Set the wireless LAN connection using the push button or PIN code method.
• Refer to the manual of the access point device for its operation.
• Not available when [Wi-Fi Direct] is active.
The setting items are as follows:
[Button (PBC)]
Set the wireless LAN connection using the push button method.
1. Tap [Button (PBC)] in the [Wi-Fi Protected Setup(WPS)] menu.
2. When [Scanning...] appears on the screen, press the WPS button on the access point of the
wireless LAN device.
3. When the connection to the access point is established, [Successfully configured.] appears on the
screen.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
