SATO FX3-LX - Page 396

[Printing] Menu
396
Setting Item Initial Value
[Eject Cut] Off
[Darkness] 5
[Imaging]
[Vertical] 0 dot
[Horizontal] 0 dot
[Advanced]
[Calibrate]
[Auto-calibration] -
[GAP Levels] Value adjusted by the factory.
[GAP Slice Level] Auto
[I-Mark Levels] Value adjusted by the factory.
[I-Mark Slice Level] Auto
[Dispenser Levels] Value adjusted by the factory.
[Linerless Levels] Value adjusted by the factory.
[Head Check] Off
[Head Check Mode] Always
[Every Page] 1
[Check Media Size] Disabled
[Adjustments]
[Offset] 0 dot
[Pitch] 0 dot
[Darkness Adjust] 50
[Start Online] Disabled
[Feed After Error] Enabled
[Feed At Power On] Disabled
[Finisher Feed] 0 dot (Standard)
[Paper End] Using I-mark
[Prioritize] Commands