SciCan Statim 2000 - Removing and Replacing the LCD Touchscreen

Page 136
STAT IM 2000/2000S Service Guide
96-108639 Rev 3.0
6. Cover Assembly
STATIM 2000/2000S/2000 G4 Service Guide
Removing and Replacing the STAT IM 2000 G4
Colour LCD Touchscreen
Note: To replace the colour LCD touchscreen you will also need a new LCD overlay.
To remove the colour LCD touchscreen LCD overlay and remove the cover to access the inside of
the fascia (see Figure 8).
1. With the cover upside down on a work surface, disconnect the flexible PCB connector (1)
cable connecting the colour LCD (2) to the LCD controller board (3). It is connected to the LCD
controller board using a hinged catch (4). With your fingernail, pull on the door of the hinged
catch to release the flexible PCB connector.
2. Turn the cover right side up and carefully remove the LCD overlay (5) from the fascia (6) and
discard it.
3. The colour LCD touchscreen is held in place with two-sided adhesive tape. If it does not come
off easily, put a small screwdriver in the PCB connector cable slit and push upwards.
To replace the colour LCD touchscreen, follow these steps:
1. Align the colour LCD touchscreen in the recessed area in the fascia.
NOTE: Do not press down in the middle of the colour LCD assembly. Apply pressure around
the frame of the LCD.
2. Replace the LCD overlay with a new overlay.
3. Turn the cover upside down to access the inside of the fascia.
4. Connect the flexible PCB connector, pushing it down into position and closing the hinged
connector. Give the flexible PCB connector a gentle tug to ensure it is properly held in
position.
5. Connect the LCD controller board power cable to the DC power source and plug in the unit.
6. Power ON the unit to test the colour LCD touchscreen.