SciCan Statim 2000 - Recommended Printers

Page 248
STAT IM 2000/2000S Service Guide
96-108639 Rev 3.0
12. Printer and Data Logger
Recommended Printers for STATIMs with
Revision 7 Controller Boards
The following printers have been tested by SciCan and are recommended for use as an external
printer for STATIM units with Rev. 7 boards. They may be purchased from your local computer
store or from an online supplier.
Important notes:
 t5IFQSJOUFSTSFGFSFODFEBCPWF.":CFTVQFSTFEFEGSPNUJNFUPUJNF5IFVQEBUFE
equivalent MAY be able to be used with your STATIM unit but it is important to
ensure that the ‘End of Line CR/LF’, ‘Serial Port Bitrate’ and ‘Printer uses º char’
are appropriate to the new printer.
 t4PNFPGUIFSFGFSFODFOVNCFSTBCPWFNBZDPOUBJOWPMUBHFSFGFSFODFTFH
SP212FD42-120). If the voltage in your region is different, then you should ensure
that you obtain a printer with the correct voltage (e.g., for a 230V territory, the
printer reference should be SP212FD42-230).
STATIM 2000/2000S/2000 G4 Service Guide