Page 49
STAT
IM
2000/2000S Service Guide
96-108639 Rev 3.0
3. Troubleshooting Cycle Faults
STATIM 2000/2000S/2000 G4 Service Guide
The following menu is now available and the display on the LCD screen of the unit or control box
will be a two-line display as highlighted by the bolded box in the following table.
Note that to navigate the menu you can use the keypad buttons that will operate the following
selections:
“Unwrapped” button - Selects the next item in the menu (down)
“Wrapped” button - Selects the previous item in the menu (up)
“Rubber and Plastics” button - Enters the indicated sub-menu item (as indicated by the cursor “>”)
“Stop” button - Exits the menu and returns the unit to operational mode
>Calibration
Time/Date setup
Language setup
Unit ID setup
Set cycle counter
Lock cycles For S class units only
Conductivity setup
Water. cnd tmp. comp
Last printout
Stored CF printouts
Clear CF printouts
Display last CF#
Devices test On/Off
Temperature offset
Press. atm. offset For S class units only
Press. ster. offset For S class units only
Press. sensor type For S class units only
Validation offset For non-S class units only
Voltage calibration
Voltage setup
Repeater mode
RS232
End of line CR/LF
Serial port bitrate
Printer user ß char
Factory default
Change password
Backup NVRAM
Restore NVRAM
Save and exit
Exit
Water pump type
Production cycle
To Next Page
Loading...
