SICK microScan3 Pro I/O User Manual

✓
P
ossible pins for the connection are highlighted.
Safety Designer checks for any restrictions that may apply. For example, an OSSD
c
annot be placed on an input.
b
Dr
op the signal on the pin.
✓
The signal name is shown on the right next to the pins.
Removing signals
b
Clic
k on the signal.
b
Drag the signal on to the trash-can symbol.
✓
The pins are free again.
7.13.1 Outputs
OSSD
O
SSD pair.
Contamination
S
ignals that the optics cover is contaminated.
•
Partial contamination, optical cover should be cleaned soon (contamination warning). setting:
The optics cover needs to be cleaned soon.
•
Switch the safety laser scanner to the OFF state in the event of severe contamination (contami‐
nation error). setting: All safety outputs in the OFF state. The optics cover is severely
contaminated and must be cleaned immediately.
Error
S
ignals an error.
•
Device error setting: Device errors are serious errors where all safety outputs switch
to the OFF state and the device switches to the locking state. Once the cause of
the error has been rectified, the device must be completely restarted.
•
Application error setting: In the event of an application error, all safety outputs
switch to the OFF state. Once the cause of the error has been rectified, the safety
function must be restarted.
Reset required
S
ignals that a reset is possible. A connected lamp lights up if the restart interlock has
been triggered and the protective field is then clear again.
Monitoring result
Indic
ates the status of the active field. A connected lamp lights up if an object is
detected in the field.
Reset required (flashing)
S
ignals that a reset is possible. A connected lamp flashes if the restart interlock has
been triggered and the protective field is then clear again.
Further topics
•
"St
atus indicator with the display", page 155
7.13.2 Inputs
Static control input
S
ignal of the machine controller for switching between monitoring cases.
7 C
ONFIGURATION
132
O P E R A T I N G I N S T R U C T I O N S | microScan3 Pro I/O 8025424/1ELL/2022-01-21 | SICK
Subject to change without notice

SICK microScan3 Pro I/O Specifications

General

Scanning angle	275°
Number of fields	128
Dimensions	102 mm x 152 mm x 106 mm
Number of safety outputs	2
Number of OSSD outputs	2
Scanning range	5.5 m
Protective field range	5.5 m
Resolution	30 mm
Number of monitoring cases	128
Response time	60 ms
Interfaces	Ethernet, USB
Operating temperature	+50 °C
Protection class	IP65
Supply voltage	24 V DC
Storage temperature	+70°C
Operating voltage	24 V DC (16.8 V DC ... 28.8 V DC)
Housing material	Plastic
Connection type	Male connector