Siemens HydroRanger 200 HMI - Page 401

Index
HydroRanger 200 HMI
Operating Instructions, 06/2018, A5E36281317-AC
399
Transducers
average or differential, 92, 93
common problems chart, 283
common wiring problems, 288
conditions for optimum accuracy, 44
connecting, 353
connecting with RG62 co-axial extension, 354
distance calculation, 305
EchoMax and ST-H, 44, 300
fixed reading, 290
frequency, 300
ignoring bad echo, 291
index types, 161
installing a transducer with narrower beam, 290
LOE, 289
noise problems, 286
obstructions in the sound beam, 290
parameter, indexing, 158
parameter, Siemens transducers connected, 164
point data, 330
scanning, 307
selector, 158
Siemens models connected, 62, 67, 74
sound velocity, 306
transmit pulse, 301
XPS-10, preset to, 91
XRS-5, 89
Transmit pulse, 301
TVT (time varying threshold), 302
advanced TVT adjustment, 368
algorithm, 304
parameters, TVT setup, 227
parameters, TVT slope minimum,
231
Par
ameters, TVT type, 230
shaper mode, 229
TVT dB, 230
TVT ms, 231
TVT shaper, 231
U
Universal calculation
support, 151
Unsigned double precision integer. See also data
types., 340
Upgrading to a new Siemens level controller, 353
V
Velocity, 306
Volume, 109
calculation, 307
conversion, 305
flow samplers, 136
numeric values, 339
OCM (open channel monitoring). See also OCM
(open channel monitoring), 137
parameters, breakpoints (table 1-8), 190
parameters, current output function, 181
parameters, default auxiliary reading, 239
parameters, inflow/discharge adjust, 189
parameters, maximum volume, 188
parameters, sensor mode, 163
parameters, volume, 185
parameters, volume rate, 257
point data, 330
pumped volume, 109, 134, 135, 332, 332
pumped volume, totalizing, 127
totalized, 140
troubleshooting, 285
Volume
dimensions, 94
Volume
pumped volume, 109, 134, 135, 332, 332