Siemens SIMATIC ITC1200 V3 - Page 170

Technical specifications
8.1 Labels, certificates and approvals
ITC V3, ITC V3 PRO
170 Operating Instructions, 03/2024, A5E42761061-AF
ATEX/UKEX approval
For an HMI device with "Ex" marking, the following approvals apply according to the
following standards.
• Standards:
– EN IEC 60079-0
– EN IEC 60079-7
– EN 60079-31
• Approvals:
II 3 G
Ex ec IIC T4 Gc
II 3 D
Ex tc IIIC T 70 °C Dc
ATEX certificate number
• Devices with article numbers -...0: DEKRA 19ATEX0111 X
• Devices with article numbers -...1: UL 23 ATEX 3022X
UKEX certificate number
• Devices with article numbers -...0: DEKRA 21UKEX0014X
• Devices with article numbers -...1: UL24UKEX2975X
IECEx approval
For an HMI device with "IECEx" marking, the following approvals apply according to the
following standards.
• Standards:
– IEC 60079-0
– IEC 60079-7
– IEC 60079-31
• Approvals:
Ex ec IIC T4 Gc
Ex tc IIIC T 70°C Dc
IECEx certificate number
• Devices with article numbers -...0: IECEx DEK 19.0071X
• Devices with article numbers -...1: IECEx UL 23.0042X
Special conditions of use for ITC V3 built-in devices
• When used in an area requiring the use of equipment with EPL Gc, the following
additional conditions apply:
– The equipment shall only be used in an area of at least pollution degree 2, as defined
in IEC 60664-1.
– Transient protection shall be provided that is set at a level not exceeding 119V, which
is 140% of the peak rated voltage value at the supply terminals to the equipment.