ITC Operating mode
5.5 Assigning device parameters
ITC V3, ITC V3 PRO
98 Operating Instructions, 03/2024, A5E42761061-AF
You select a client-server connection, or create a new one. The following connection settings
can be specified:
-out fields
Not all connection settings are available for each connection type (exception: RDP).
Connection settings that are not required are grayed out.
• The "Connection type" specifies the type of client-server connection, e.g. RDP connection,
VNC connection, etc.
• In "Connection name", you enter a name for the client-server connection, e.g. "Server
screen 1". The client-server connection will then appear with this name in selection
menus. If the operator selects "Server screen 1" in the taskbar, for example, the client-
server connection configured with this name will be started.
• In "Description", you enter a text for the client-server connection. This description then
appears in selection menus under "Connection name".
• Under "Server (IP address)", you specify an IP address or host name at which the server can
be reached.
• In "URL" ("Web" connection type only), you specify an Internet address at which the web
server can be reached.
• The default port is set under "Port". RDP: 3389, Sm@rtServer/VNC: 5900.
• In "Start program" (RDP only), you specify the software program that is automatically
started on the server with this RDP connection. For this function, a "Server" type operating
system is required on the server PC. The server must be configured accordingly.
• Under "Redundant 2nd server" (RDP only), select a second RDP connection that is already
configured. If the first RDP connection configured here fails, the second RDP connection
will be started (fallback). And vice versa: If the second RDP connection fails, the first RDP
connection will be restarted.
To use two redundant RDP connections, the following options must be enabled for both
connections:
– "Show connection (Favorites)"
– "Reconnect automatically"
If the "Redundant 2nd server" and "Reconnect automatically" options are enabled, three
attempts, with a time interval of about 15 seconds, are made to restore the currently
active connection before the start of the other connection.
• Under "Kerberos Distribution Center", enter the name of the Kerberos server for Kerberos
authentication.
For a successful RDP connection with Kerberos authentication, fill in the following input
fields:
– "Kerberos Distribution Center": Computer name of the Kerberos server.
– "Server": Computer name of the server that the client wants to use.
– "Domain": Name of the domain in which both servers are located.
To Next Page
Loading...
