Siemens SIMOCODE pro

System description
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
1-83
Voltage display
Switch voltage display
Note
Only available for OPDs above version *E04* and BU2 above
version *E06*.
From BU2 product version *E07, configuration is carried out in the
BU.
Determines whether "phase voltages" or "line-to-line voltages" are
displayed.
Phase voltages
Line-to-line voltages
Warnings
Determines whether, in the case of a pending general warning, the
display is switched over to the menu item "Warnings" so that details
are displayed (not switched on as standard).
Do not display
Display
Faults
Determines whether, in the case of a pending general fault, the
display is switched over to the menu item "Faults" so that details are
displayed (switched on as standard, higher priority than pending
warnings).
Do not display
Display
Table 1-16: Adapt display settings (Cont.)