Siemens SIMOCODE pro System Manual

Mounting, wiring, interfaces
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
13-25
13.3.2 Digital modules DM-F Local and DM-F PROFIsafe
Wiring:
See system manual "Failsafe Digital Modules SIMOCODE pro SAFETY",
Chapter 5 "Mounting and connection".
Warning
Loss of safety function possible.
For the 24 V DC power supply, always use a power supply according to IEC
60536 protection class III (SELV or PELV).
Note
Surge suppressors are required for inductive loads.

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000