Siemens SIMOCODE pro System Manual

SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
11-1
Logic modules 11
In this chapter
In this chapter you will find information on the SIMOCODE pro logic
modules. Logic modules are function blocks which are modeled not only on
standard logic functions, e.g. truth tables (AND, OR,...), but also on counters
and timers. In addition to the predefined control functions, you can use this,
for example, to implement logical functions, time relay functions and
counter functions without depending on external components (relays).
Target groups
This chapter is addressed to the following target groups:
• Configurators
• Programmers.
Necessary knowledge
You will require the following knowledge:
• The principle of connecting plugs to sockets
• The basics of digital signal processing, e.g. timers, counters, etc.
Navigation in SIMOCODE ES
You will find the dialogs in SIMOCODE ES under:
Further function blocks > Logic modules.

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000