Siemens SIMOCODE pro System Manual

Logic modules
SIMOCODE pro
11-10 GWA 4NEB 631 6050-22 DS 03
11.6 Timer
Description
The timer consists of:
• Two plugs (input and reset)
• One socket.
• One "Actual value" analog socket with the actual value.
The actual value is available as a socket for further internal processing and
can also be transmitted to the automation system.
If an input signal is pending, the timer can issue an output signal according
to the chosen timer type:
• With closing delay
• With closing delay with memory
• With opening delay
• Fleeting closing.
Overall, the following are available:
– Two timers, 1 to 2 for BU1
– Four timers, 1 to 4 for BU2
Schematic
The following schematic shows the "Timer" logic modules
Fig. 11-9: "Timer" logic modules
Note
The output is always 0 if a reset is pending.
Timer 1
Input
Reset
Output
Value
Type
Timer 2
Input
Reset
Output
Value
Type
Timer 3
Input
Reset
Output
Value
Type
Timer 4
Input
Reset
Output
Value
Type
Actual value Actual value
Actual value
Actual value

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000