EasyManuals Logo

Siemens SIMOCODE pro System Manual

Siemens SIMOCODE pro
694 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #289 background imageLoading...
Page #289 background image
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
7-1
Inputs 7
In this chapter
In this chapter you will find information on the inputs of SIMOCODE pro.
The inputs are:
Binary inputs on the basic units and digital modules
Operator panel buttons
Temperature module inputs
Analog module inputs
Receive data from PROFIBUS DP.
Target groups
This chapter is addressed to the following target groups:
Planners and configurators
Planners.
Necessary knowledge
You will require the following knowledge:
The principle of connecting plugs to sockets.
Navigation in SIMOCODE ES
You will find the dialogs in SIMOCODE ES under:
Device parameters > Inputs.

Table of Contents

Other manuals for Siemens SIMOCODE pro

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMOCODE pro and is the answer not in the manual?

Siemens SIMOCODE pro Specifications

General IconGeneral
Protection ClassIP20
Mounting TypeDIN rail mounting
Rated Operational Voltage24 V DC
Rated CurrentUp to 820 A
Protection FunctionsOverload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range-25°C to +60°C
Communication ProtocolsPROFIBUS DP, PROFINET, Modbus RTU
Analog OutputsUp to 2
Temperature MonitoringPTC/KTY, RTD (PT100/PT1000)
Digital OutputsRelay outputs, Solid-state outputs
Analog Inputs0/4-20mA, PT100/PT1000

Related product manuals