Siemens SIMOCODE pro System Manual

System description
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
1-19
1.5.3 Control functions
Depending on the device series, the following parameterizable control
functions are available:
All the necessary protection functions and interlocks are already available
and can be flexibly adapted and expanded.
For a detailed description of the individual control functions: See
Chapter 4 "Motor control".
SIMOCODE
Control function pro C
(BU1)
pro V
(BU2)
Overload relay ✓ ✓
1)
Direct starter ✓ ✓
1)
Reversing starter ✓ ✓
1)
Molded case circuit breaker (MCCB) ✓ ✓
1)
Star-delta starter,
star-delta reversing starter
— ✓
Dahlander,
Dahlander reversing starter
— ✓
Pole-changing starter,
Pole-changing reversing starter
— ✓
Solenoid valve — ✓
Positioner — ✓
Soft starter,
Soft starter with reversing contactor
— ✓
Table 1-2: Control functions
1) Due to additional requirements (e.g. power measuring), it may be necessary
to select the BU2 device version.

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000