Inputs
SIMOCODE pro
7-4 GWA 4NEB 631 6050-22 DS 03
7.2 Basic unit inputs
Description
SIMOCODE pro has a "BU Inputs" function block with four binary inputs with
common ground potential. You can connect the buttons for a local control
station to the inputs. These signals can be further processed in
SIMOCODE pro by internally connecting the sockets of the "BU Inputs"
function block.
The "BU Inputs" function block consists of:
• Input terminals located on the outside of the basic unit, corresponding to
the sockets "BU Input 1" to "BU Input 4"
• Sockets in SIMOCODE pro that can be connected to any plugs, e.g. to the
"Control Stations" function block
• A socket for the "Test/Reset" button:
The function of the "Test/Reset" button is generally dependent upon the
operating status of the device:
- Reset function for the acknowledgement of pending faults
- Test function for carrying out device tests.
In addition, other functions can be assigned to the "Test/Reset" button (e.g.
operation of the memory module and the addressing plug).
For this, see also Chapter 10.2 "Test/Reset".
Overall, there is one "BU Inputs" function block for BU1 and BU2.
Schematic
The following schematic shows the "BU Inputs" function block:
Fig. 7-2: Schematic of the "BU Inputs" function block
Basic unit (BU)
9
10
4
5
BU Inputs
1
2
3
4
Termina l
numbers
IN1
IN2
IN3
IN4
BU Test/Reset button
8
Button
Test/Reset
To Next Page
Loading...
Need help?
General
