Siemens SIMOCODE pro System Manual

SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
14-1
Commissioning and service 14
In this chapter
In this chapter you will find information about how SIMOCODE pro is
commissioned, how components are replaced and how statistics are read.
Target groups
This chapter is addressed to the following target groups:
• Commissioners
• Technicians
• Maintenance and service personnel.
Necessary knowledge
You will require the following knowledge:
• General basic knowledge about SIMOCODE pro, e.g. from Chapter 1
• SIMOCODE ES software.

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000