Siemens SIMOCODE pro System Manual

SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
1-1
System description 1
In this chapter
In this chapter you will find an introduction and general information about
the SIMOCODE pro system including e.g.
• Characteristics of both the SIMOCODE pro C and the SIMOCODE pro V
device series
• Simplification of SIMOCODE pro circuits
• Overview of functions
• An overview of system components.
Target groups
This chapter is addressed to the following target groups:
• Planners and configurators
• People who are now using SIMOCODE DP but wish to use SIMOCODE pro
as a replacement or additional system in the future
• Optional for commissioners, maintenance and service personnel as additional
information "about SIMOCODE pro"
• System integrators/process technology.
Necessary knowledge
You will require the following knowledge:
• Basic knowledge about load feeders
• Basic knowledge about motor protection
• Basic knowledge of control engineering
• Basic knowledge of industrial bus technology.

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000