Siemens SIMOCODE pro System Manual

SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
4-1
Motor control 4
In this chapter
In this chapter you will find information on:
• Control stations which you can select and enable according to need. The
following related topics are explained:
– How control stations, operating modes and releases work together,
– How control commands, e.g. "ON", "OFF", are switched through to the
control function.
• Control functions you can select according to need. The following related
topics are explained:
– How control commands, e.g. "ON", "OFF", are switched through from
the control stations to the contactor controls/relay outputs
– Which parameters apply depending on the control function chosen.
Target groups
This chapter is addressed to the following target groups:
• Configurators
• PLC programmers.
Necessary knowledge
You will require the following knowledge:
• The principle of connecting plugs to sockets
• Electrical drive engineering
• Motor protection.
Navigation in SIMOCODE ES
You will find the dialogs in SIMOCODE ES under:
Device parameter > Motor control.

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000