Siemens SIMOCODE pro System Manual

SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
12-1
Communication 12
In this chapter
In this chapter you will find information about the options of SIMOCODE pro
communication, e.g. communication with a PLC. The default receive, send
and diagnostics data settings are sufficient for almost all applications and as
such, the parameterization only has to be changed to a small extent.
Otherwise, you can adapt the settings of the individual bits specifically for
your application.
Target groups
This chapter is addressed to the following target groups:
• Configurators
• PLC programmers.
Necessary knowledge
You will require the following knowledge:
• The principle of connecting plugs to sockets
• Knowledge about PROFIBUS DP.
Navigation in SIMOCODE ES
You will find the following dialogs in SIMOCODE ES:
Device Parameters > Bus Parameters
Further function blocks > Outputs > Acyclic send data
Further function blocks >Outputs > Cyclic send data.

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000