Siemens SIMOCODE pro System Manual

SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
E-1
Example circuits E
In this chapter
In this chapter you will find example circuits for the following
parameterizable control functions:
– Overload relay
– Direct starter
– Reversing starter
– Molded case circuit breaker (MCCB)
– Star-delta starter
– Star-delta reversing starter
– Dahlander
– Dahlander reversing starter
– Pole-changing starter
– Pole-changing reversing starter
– Solenoid valve
– Positioner
– Soft starter
– Soft starter with reversing contactor
– Direct starter for 1-phase loads
Target groups
This manual is addressed to the following target groups:
• Planners
• Configurators
• Technicians
• Electricians
• Commissioners.
Necessary knowledge
You will require the following knowledge:
• Basic SIMOCODE pro knowledge (see Chapter 1)
• Basic knowledge of SIMOCODE ES parameterization software.

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000