SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
2-1
Short instructions for configuring
a reversing starter
2
In this chapter
In this chapter you will find short instructions for configuring a reversing
starter, with the aid of a practical example. The majority of the parameters
have been appropriately preset at the factory for most applications.
You only need to set a few parameters.
Target groups
This chapter is addressed to the following target groups:
• Planners
• Configurators
• Technicians
• Electricians
• Commissioners.
Necessary knowledge
You will require the following knowledge:
• Basic SIMOCODE pro knowledge (see Chapter 1 "System description")
• Basic knowledge of SIMOCODE ES parameterization software.
To Next Page
Loading...
