Siemens SIMOCODE pro

Tables
SIMOCODE pro
A-14 GWA 4NEB 631 6050-22 DS 03
A.5 Detailed messages of the slave diagnostics
The following table contains the detailed messages of the slave diagnostics
for status information and the process alarm. This information is also
contained in data record 92.
Byte.Bit Status information Information
0.0 Trip - Controlling Trip - Execution ON command BU1 BU2
0.1 Trip - Execution STOP command BU1 BU2
0.2 Trip - FB ON BU1 BU2
0.3 Trip - FB OFF BU1 BU2
0.4 Trip - Stalled positioner BU1 BU2
0.5 Trip - Double 0 BU1 BU2
0.6 Trip - Double 1 BU1 BU2
0.7 Trip - End position BU1 BU2
1.0 Trip - Antivalence BU1 BU2
1.1 Trip - Cold starting (TPF) fault BU1 BU2
1.2 Trip - UVO fault BU2
1.3 Trip - OPO fault BU2
1.4 Reserved
2.0 Reserved
2.1 Trip - Protection Trip - Unbalance IM UM
2.2 Trip - Overload IM UM
2.3 Trip - Overload + phase failure IM UM
2.4 Trip - Int. earth fault IM UM
2.5 Trip - Ext. earth fault EM
2.6 Reserved
2.7 Trip - Thermistor overload Th
3.0 Trip - Thermistor short circuit Th
3.1 Trip - Thermistor open circuit Th
3.2 Reserved
3.3 Trip - TM tripping T> TM
3.4 Trip - TM sensor fault TM
3.5 Trip - TM out of range TM
3.6 Reserved
4.0 Trips -
Level monitoring
Trip - Trip I> IM UM
4.1 Trip - Trip I< IM UM
4.2 Trip - Trip P> UM
4.3 Trip - Trip P< UM
4.4 Trip - Trip cos phi< UM
4.5 Trip - Trip U< UM
4.6 Trip - Trip 0/4-20 mA> AM
4.7 Trip - Trip 0/4-20 mA< AM
5.0 Trip - Stalled rotor IM UM
5.1 Reserved
Table A-5: Detailed messages of the slave diagnostics