Siemens SIMOCODE pro System Manual

SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
10-1
Standard functions 10
In this chapter
In this chapter you will find information about the standard functions stored
as function blocks in SIMOCODE pro. Standard functions are typical motor
functions that can be activated according to need and, as applicable,
individually set for each motor feeder.
Target groups
This chapter is addressed to the following target groups:
• Configurators
• Programmers of application programs for reference purposes.
Necessary knowledge
You will require the following knowledge:
• The principle of connecting plugs to sockets
• Motor protection
• Control functions, control stations.
Navigation in SIMOCODE ES
You will find the dialogs in SIMOCODE ES under:
Further function blocks > Standard functions.

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000