Siemens SIMOCODE pro System Manual

SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
6-1
Outputs 6
In this chapter
In this chapter you will find information about the outputs of
SIMOCODE pro:
• Relay outputs on the basic unit and the digital modules
• Analog module output
• Operator panel LEDs
• Send Data on the PROFIBUS DP.
Target groups
This chapter is addressed to the following target groups:
• Planners and configurators
• Programmers.
Necessary knowledge
You will require the following knowledge:
• The principle of connecting plugs to sockets
•PROFIBUSDP.
Navigation in SIMOCODE ES
You will find the dialogs in SIMOCODE ES under:
Further Function Blocks > Outputs.

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000