Siemens SIMOCODE pro System Manual

Mounting, wiring, interfaces
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
13-41
Notice
Only a current/voltage measuring module may be connected to the system
interface on the right of the decoupling module. Memory modules,
addressing plugs or PC cables will not be recognized there.
Notice
Observe the color coding for the connecting cable (see diagram)!
13.4.3 System interfaces on the digital modules DM-F Local or DM-F PROFIsafe
See system manual "Failsafe Digital Modules SIMOCODE pro SAFETY",
Chapter 5 "Mounting and connection".

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000