Siemens SIMOCODE pro

System description
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
1-85
Resetting, testing and parameterizing via commands
The "Commands" menu item contains all commands relating to
SIMOCODE pro e.g. for testing the feeder, resetting after tripping and/or
adopting parameters into the memory module or into SIMOCODE pro. By
safeguarding the device-internal parameterization against external access,
e.g. via a password stipulated in SIMOCODE pro, individual commands and/
or even the entire "Commands" menu item can be blocked.
Table 1-17: Resetting, testing and parameterizing via commands
Test/Reset Only if the Test/Reset button has not been blocked.
Adopt address Only if the Test/Reset button has not been blocked and a password
has not been stipulated.
Program Only if the Test/Reset button has not been blocked.
Clear Always possible.
Read Only if the Test/Reset button has not been blocked and a password
has not been stipulated.
Restart Only if the Test/Reset button has not been blocked.
Factory settings Only if the Test/Reset button has not been blocked.