System description
SIMOCODE pro
1-112 GWA 4NEB 631 6050-22 DS 03
Sockets
(analog)
Function blocks in the basic units may have analog
sockets. Sockets are assigned via software to analog
plugs.
They are relevant for parameterization, e.g. with
SIMOCODE ES.
Example: 2-byte word max. current I_max.
Screw
terminals
Screw terminals are outside, e.g. "BU Output"
function block. The contactors, for example, are
connected here.
Send data to
PROFIBUS DP
From SIMOCODE pro to the DP-Master, e.g."Cyclic
Send" function block.
Binary terminal
block
Internal binary signals (binary sockets) that are not
assigned to a function block (fault, status, other),
e.g. "Status - Device OK." (in the graphic editor).
Analog terminal
block
Internal analog signals (analog sockets) that are not
assigned to a function block, e.g. "Phase Unbalance"
(in the graphic editor).
Table 1-28: Input types of the internal function blocks of SIMOCODE pro
To Next Page
Loading...
