Siemens SIMOCODE pro System Manual

Motor control
SIMOCODE pro
4-28 GWA 4NEB 631 6050-22 DS 03
Schematic
Fig. 4-15: Schematic of the "circuit breaker" control function, "Protection/Control" function block
Separate failsafe
control function
Control commands
Auxiliary control inputs
Contactor controls
Displays
Status
QE1
QE3
FB ON*
QLA
QLE>
QLS
OFF
ON >
400 ms
400 ms
OFF
ON >
Protection/Control
Feedback time
Execution time
Non-maintained
Load type
(ON)
(OFF)
(Fault)
*Feedback ON
Circuit breaker
Motor protection
ON
OFF
Auxiliary switch (AS)
command mode
function from

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000