System description
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
1-5
• Two speeds, motors with separate windings (pole-changing starters), also
with reversing starter (see Chapter 4.2.11 and Chapter 4.2.12)
• Two speeds, motors with separate Dahlander windings, also with reversing
starter (see Chapter 4.2.9 and Chapter 4.2.10)
• Positioner control (see Chapter 4.2.14)
• Solenoid valve control (see Chapter 4.2.13)
• Circuit breaker control (see Chapter 4.2.6)
• Soft starter control, also soft starter with reversing contactor (see
Chapter 4.2.15 and Chapter 4.2.16).
These control functions are pre-defined in SIMOCODE pro and can be
assigned freely to device inputs and outputs (including PROFIBUS DP).
These pre-defined control functions can also be adjusted flexibly to meet
customer requirements of the motor feeder, without requiring additional
auxiliary relays in the control circuit. This is achieved by means of freely-
parameterizable logic modules (truth tables, counters, timers, edge
evaluation, etc., see Chapter 11 "Logic modules") and standard functions
(external power failure monitoring, emergency start, external fault
monitoring etc., see Chapter 10 "Standard functions").
Detailed operating service and diagnostic data:
SIMOCODE pro provides a range of operating, service and diagnostic data
and helps to detect impending faults in good time and stop these occurring
with preventative measures. If a fault occurs, it can be diagnosed, traced
and resolved within a short period of time. Plant downtime is thus reduced
to a minimum or does not occur at all.
See Chapter 1.5.7.
Communication:
SIMOCODE pro has an integrated PROFIBUS DP interface (SUB-D socket or
terminal connection). This replaces all individual wiring and distribution
boxes (normally required to exchange data with a higher-level automation
system) with a single two-wire cable.
SIMOCODE pro supports:
• Baud rates up to 12 Mbit/s
• Automatic baud rate recognition
• Communication with up to 3 masters
• Time synchronization via PROFIBUS (SIMATIC S7)
• Time stamping with high temporal precision (SIMATIC S7)
• Cyclic services (DPV0) and acyclic services (DPV1)
• DPV1 communication downstream from the Y-link.
See Chapter 12 "Communication".
To Next Page
Loading...
Need help?
General
