Siemens SIMOCODE pro System Manual

Monitoring functions
SIMOCODE pro
GWA 4NEB 631 6050- 22 DS 03
5-21
Response at pre-warning
Here you can set the response required after the second to last start:
See also "Tables of responses of SIMOCODE pro" in Chapter "Important
information" and Table 5-15.
Interlocking time
If a new start command is issued within the time range for starts after the
last permissible start, this new start command will no longer be executed if
the setting "Response at overshoot - Tripping" has been set. "Trip - No. of
starts >" will be displayed and the set interlocking time activated.
Interlocking time: 00:00:00 to 18:12:15 hh:mm:ss

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000