Outputs
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
6-5
– Lamp test: All QL outputs are activated for approx. 2 s.
In most cases, the outputs of the basic unit will be connected to the QE or
QL outputs. By referring to Table 4-21 on page 4-65 you can determine
which QE outputs are required for which control functions.
Settings
Defaults depend on the selected application (template): See Chapter E
"Example circuits".
BU Outputs Description
Outputs 1 to 3 Control of the "BU Outputs" function block via any signal
(any sockets ,
e.g. device inputs, control bits from PROFIBUS DP, etc.
usually from the QE contactor controls)
Table 6-2: Basic unit output settings
To Next Page
Loading...
Need help?
General
