Siemens SIMOCODE pro System Manual

Logic modules
SIMOCODE pro
11-14 GWA 4NEB 631 6050-22 DS 03
Settings
Timers 1 to 4 - Description
Input Activation by any signal
(arbitrary sockets , e.g. device inputs, control bits from
PROFIBUS DP, etc.)
Reset Resets the actual value to 0.
Activation by any signal
(arbitrary sockets , e.g. device inputs, control bits from
PROFIBUS DP, etc.)
Type Different output responses
Range: Closing delay, closing delay with memory,
opening delay, fleeting closing
Value Time during which the timer provides an output signal when
activated, depending on the output response (type)
Range: 0
to 65535, unit 100 ms
Table 11-5: Timer settings

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000