Siemens SIMOCODE pro System Manual

System description
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
1-27
Accessories
SIMOCODE basic unit
Connectable
system components
pro C (BU1) pro V (BU2) Application
Connecting cable in various
lengths, ranging from 0.025 m up
to 2.5 m
For connecting
system components
via system interfaces
System interface cover For covering unused
system interfaces
Memory module Saving device
parameters. If a
device is replaced,
parameter transfer
without PC
Addressing plug Configuring the
PROFIBUS DP
address without a PC
PC cable Connecting
SIMOCODE pro to
aPC
USB to serial adapter For connecting a RS-
232 cable to the USB
interface of a PC.
Door adapter Only for leading out
the system interface,
e.g. from a switchgear
cabinet
Operator panel adapter Enables the use of the
smaller 3UF720
operator panel in the
front panel cut-out of
the 3UF52 operator
panel or the 3UF721
operator panel with
display.
Table 1-7: System components, accessories

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000